Pin Mapping for Orange Pi 4 LTS for ADXL345 - General Discussion - Klipper

I am using an Orange Pi 4 LTS to run Klipper, and I am trying to connect my ADXL345 which was previously connected to a Rpi3B. It has a 23 pin header instead of 40- is this possible? These are the two pinout diagrams, but I cannot find an Rpi mapping, nor make sense of the names enough to convert. Any help is appreciated!

Libre Computer AML-S905X-CC Le Potato

PDF) Development of a Low-Cost Vibration Measurement System for

Setting up ADXL345 on orange pi lite 2 - General Discussion - Klipper

Orange Pi 3 LTS ADXL345 : r/klippers

ADXL345 Raspberry pi4 multi SPI - General Discussion - Klipper

PDF) Development of a Low-Cost Vibration Measurement System for

Is it possible to connect adxl345 to orangepi 3 lts? : r/OrangePI

Orange Pi 3 LTS ADXL345 : r/klippers

Is it possible to connect adxl345 to orangepi 3 lts? : r/OrangePI

Orange Pi 4 LTS GPIO and Mainsail/Moonraker/Klipper : r/OrangePI

Pin Mapping for Orange Pi 4 LTS for ADXL345 - General Discussion

Libre Computer AML-S905X-CC Le Potato - Computadora de

Ender 3 Neo V2 + Orange PI 3 LTS + ADXL345 - success! : r/klippers

Is it possible to connect adxl345 to orangepi 3 lts? : r/OrangePI